Con i settaggi che seguono dovresti andare tranquillamente a 4200Mhz sulla cpu e le ram come da dati di targa.Dove non ho scritto nulla lascialo per come lo trovi.
CPU Features
PPM : Enabled
EIST : Enabled
CxE : Disabled
Execute Disable Bit : Enabled
Virtualization : Enabled
Hyper Threading : Enabled
Active Processor Cores : All
Memory Settings
Memory Controller Settings
IMC Configuration :
Channel Congifuration :
Channel Interleaving :
Rank Interleaving :
Memory Timings
Extreme Memory Profile XMP: Disabled
Memory Profile Select :
DRAM Timing Control :
tCL (CAS Latency) :7
tRCG (RAS to CAS Delay) :7
tRP (RAS Precharge) :7
tRAS (Precharge Delay) :21
CR (Command Rate) :1T
tRFC (Refresh Cycle Time) :
tWR (Write Recovery Time) :
tWTR (Write to Read Delay) :
tRRD (RAS to RAS Delay) :
tRTP (Read to Precharge) :
All Voltage Settings
CPU Voltages
CPU Core Voltage : +80mV
CPU Target Core Voltage :
CPU Vdroop Compensation: Disabled
CPU VTT (UnCore) Voltage :+80---+100
1.8 PPL Voltage Setting :1.8
CPU Clock Amplitude Ctrl :
Memory Voltages
DRAM Voltage :1.65
DIMM1 Vref CA (Addresses) :
DIMM1 Vref DQ (Data) :
DIMM2 Vref CA (Addresses) :
DIMM2 Vref DQ (Data) :
DIMM3 Vref CA (Addresses) :
DIMM3 Vref DQ (Data) :
Chipset Voltages
X58 IOH Core Voltage :
X58 IOH VCCA 1.1V :
X58 IOH VCCA 1.5V :
ICH10 SB Voltage :
OC Gear : Skipping this part
CPU Turbo : Always enable
System Turbo : Enabled
Clock Speed Control Center
CPU Bclock (FSB) : 200
QPI Link Fast Mode : Enabled
QPI Multiplier : x18
QPI Target Speed :
CPU Core Multiplier : 20
CPU Core Target Speed :
CPU Uncore Multiplier : 16
CPU Uncore Target Speed :
Memory Bus Multiplier : x8
Memory Bus Target Speed : 1600
CPU Clock Skew : 0
IOH Clock Skew :0